Replacement Car Key Fob Smart Proximity Keyless Entry Remote Control Compatible for GMC Yukon XL Denali Chevy Suburban Tahoe 2015 2016 2017 2018 2019 2020 HYQ1AA ‎13580804 315MHz Self-Programmable

Product Information

Press and hold 7 for more than three seconds to activate the panic alarm. The turn signal lamps flash and the horn sounds repeatedly for 30 seconds. The alarm turns off when the ignition is turned on or 7 is pressed again. The ignition must be off for the panic alarm to work. To remote start the vehicle, double press / from outside the vehicle using the remote key. The vehicle cannot be started if a remote key is left inside the vehicle. See Remote Vehicle Start Q: GMC key replacement cost – How much will it cost to replace GMC key without the original? What is the average price?

Passkey – The Passkey system has a separate module called the Theft Deterrent Module (TDM) that validates the resistive chip in the ignition key. If the resistance value read by the TDM is what the TDM is expecting, the TDM will send a signal to the PCM informing the PCM that a valid key is present and the PCM may start the vehicle. No relearn is required on a Passkey equipped vehicle when replacing the PCM.

Replacement GMC Keys and GMC Key Fobs

The next step is to locate the key fob programming data in the vehicle’s computer system. This data will vary depending on the model and year of your GMC Yukon. Once you’ve located the key fob programming data, you can enter the appropriate code into the scan tool and program the key fob. Insert the next key to be Turn the key to the “ON” position within 10 seconds of removing the previously used key. Programming a 2011 GMC Yukon Key Fob is a simple process that requires no special tools or expertise. By following these steps, you should be able to easily connect the key fob to the vehicle’s computer system and program it in just a few minutes. Conclusion

To perform a relearn on a Passkey II system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming. Both the BCM and PCM must be working and communicating with each other. While less expensive than a dealership, you’ll still be shelling out some cash to get a new key right away. Buying a key online Remote Key Operation The Keyless Access system allows for vehicle entry when the remote key is within 1 m (3 ft). See “Keyless Access Operation” later in this section. The remote key functions may work up to 60 m (197 ft) away from the vehicle. Other conditions can affect the performance of the remote key.You might end up paying labor costs anyway, but it’s still cheaper than a dealership and buying the hardware and their time. Do you need all your key FOBS abilities? Programming a 2011 GMC Yukon Key Fob is a relatively straightforward process that can be completed in just a few simple steps. The first step is to connect the key fob to the vehicle’s computer system. This can be done through a direct connection or via a wireless network.

Warning Never allow children to play with the remote key. The remote key contains a small battery, which can be a choking hazard. If swallowed, internal burns can occur, resulting in severe injury or death. Seek medical attention immediately if a battery is swallowed. Warning To avoid personal injury, do not touch metal surfaces on the remote key when it has been exposed to extreme heat. These surfaces can be hot to the touch at temperatures above 59 °C (138 °F). Caution When replacing the battery, do not touch any of the circuitry on the remote key. Static from your body could damage the remote key. Caution Always replace the battery with the correct type. Replacing the battery with an incorrect type could potentially create a risk of battery explosion. Dispose of used batteries according to instructions and local laws. Do not attempt to burn, crush, or cut the used battery, and avoid exposing the battery to environments with extremely low air pressures or high temperatures. Caution If the remote key is not reassembled properly, liquids could enter the housing and damage the circuitry, resulting in a remote key malfunction and/or failure. To prevent damage, always follow the steps for remote key reassembly in this manual to ensure the remote key is sealed properly whenever the remote key is opened. Replace the battery in the remote key soon if the DIC displays REPLACE BATTERY IN REMOTE KEY. To replace the battery There are fewer dealers in the United States than there are two smaller automotive shops. You might have to drive a little way to get to a dealership. Busy A key FOB most often stops working because the battery is dead or dying. The battery is often a fairly small, inexpensive fix that most people do on their own.

Wide Variety of GMC Vehicle Keys

Press and release to initiate vehicle locate. The turn signal lamps flash and the horn sounds three times.