How to Shingle a Shed Ideas

A friendly word of advice: if your building sits on a concrete slab, how to shingle a shed before you take home a riding mower. Otherwise, the mower sits in the rain while you try to figure out how to build your own ramp, or you enter and buy a thin metal one. When you figure out how much material you need and build a place your ramp can attach, you can easily put together a ramp in one afternoon.

Cedar Shingle Roof Installation

Cedar Shingle Roof Installation

Instructions

12 Photos Gallery of: How to Shingle a Shed Ideas

Image of: Windows Shingle Roof Installation

Image of: Wooden Roof Shingle Spray

Image of: Unusual Shingle Roof Installation

Image of: Small Shingle Roof Installation

Image of: Shingling A Roof Over Old Shingles

Image of: OLYMPUS DIGITAL CAMERA

Image of: Roof Shingle Spray Decor

Image of: Repair Roof Shingle Spray

Image of: Interest Roof Shingle Spray

Image of: How To Shingle A Roof Valley

Image of: Green Shingle Roof Installation

Image of: Cedar Shingle Roof Installation

 

First you need to how to shingle a shed. If you have a metal shed, you must use a special drill. Cut a 2 “x 4” pressure-impregnated bit timber slightly longer than the door opening. Attach it directly under the door. To do this, first drill 3 guide holes through the stall, one on each end and in the middle. Then the 2×4 is rolled up with the holes and drills the guide holes slightly smaller than the screws you use. Finally, screw the timber to the shed.

Then you need to measure to determine the length of your ramp. For shingle a shed should tilt at most 3 inches per linear foot. So if your building is 6 inches from the ground, you need a two meter long ramp. Determine the width of your ramp. You want to use a pressure impregnated 4 “x4” at least every 12 inches (if not more, for extra durability). If your ramp is three feet wide, you need four 4 “x4” s. Cut your 4 “X4” to the length you want the ramp to be.