How to Install Electricity in Run in Shed Plans
Run In Shed Plans – Throw outdoors your yard and garden equipment, but you may also find that you need electrical power for things such as lights and power tools. Although it is possible to do this by using wiring on the ground, running underground cable is more efficient and less visible. A good plan is to establish a line dedicated to your circuit breaker specifically to carry the energy to the ship. Although a fundamental part of this installation must be left to an electrician, much of it can be done by a useful owner.
Route planning for underground wiring. Keep the number of curves or angles in the route to a minimum. Check with your local construction department to get a permit for your work. Select a location so that the new wiring will leave the house. Choose a location near the circuit breaker on the bottom of a wall, or the top of a basement wall. Remove the drywall. Drill a 1-inch hole in this place through the wood and the liner.
12 Photos Gallery of: How to Install Electricity in Run in Shed Plans
Dig a deep crevice 24 inches approximately the width of a shovel along your path with a hoe. Place the UF cable on the ground along the length of the trench. Place an appropriate length of the electrical metal tubing, or EMT, in the box using a conduit connector. Take a curved piece from the EMT, called a sweep curve conduit, and place it at the bottom of the trench directly below the LB. Fix the LB to the house with a steel conduit strap and the masonry screw. Pass the UF cable through the sweeping curve and into the junction box. Go to the other end of the race and drill a hole in the shed connection box. The screw of the box for the wooden exterior. Make the cable connections and feed the cable into the terminal box in the same design you did for the home junction box.